Startup Steps

1. Install the software Radio Interference Equipment 12CH V1.06 on your computer.

2. Open PC Control Panel → go to Network Connections → right-click Ethernet → select Properties.

3. Open Internet Protocol Version 4 (IPv4) and set your PC IP to the 192.168.0.XXX network segment.

4. Launch the software Radio Interference Equipment 12CH V1.06.

5. Set device parameters:  Host 1: IP = 192.168.0.7, Port = 5000, ADDR = 1

                                           Host 2: IP = 192.168.0.8, Port = 5000, ADDR = 2

6. Connect the PC to the device via network cable.

7. Click Inquiry to read device data. If there is a delay, click Inquiry several times.

8. Check the bottom status bar; Data Link success!! means the connection is successful.